Open AccessMEASUREMENTS OF MASS TRANSPORT OVER A ROUGH BED
Author(s) -
J. F. A. Sleath
Publication year - 1984
Publication title -
proceedings of conference on coastal engineering/proceedings of ... conference on coastal engineering
Language(s) - English
Resource type - Journals
eISSN - 2156-1028
pISSN - 0589-087X
DOI - 10.9753/icce.v19.78
Subject(s) - reynolds number , flume , turbulence , mechanics , laminar flow , geometry , boundary layer , geology , mathematics , flow (mathematics) , physics
Measurements have been made with a laser doppler anemometer of the time-mean velocity of the fluid close to the bed in a wave flume. Both a rough bed, consisting of gravel of median diameter 11 mm, and a smooth bed were investigated. With the rough bed the time-mean velocity at a given height was found to be strongly dependent on position relative to prominent roughness elements. At one point the time-mean drift at a given height might be in the direction of wave propagation while, at another, in the opposite direction. Significant variation in time-mean drift with horizontal position was observed at all values of Reynolds number tested. The effect of bed roughness on the average value of the time-mean velocity at a given height was found to be most marked at low Reynolds numbers: the maximum near bed value with this gravel bed was about 3 times that for a smooth bed at the lowest Reynolds numbers tested. At the highest Reynolds numbers there was no clear difference between the rough and smooth bed values even though the boundary layer over the rough bed was fully turbulent whereas that over the smooth bed was laminar. However, at these high Reynolds numbers both the rough and the smooth beds showed a reduction in drift velocity below that predicted by Longuet-Higgins (9) because of the increased importance of higher harmonics in the flow.