Open AccessAnalysis of Surface Roughness and 3D Scanning Topography of Zirconia Implants Before and After Photofunctionalisation by 3D Optical Profilometry- An Invitro Study
Author(s) -
Arunjaikumar Ravindran,
Suma Karthigeyan,
Ramesh T R Bhat,
Madhulika Naidu,
Senthilnathan Natarajan,
Shilpa Sinnurkar
Publication year - 2021
Publication title -
journal of clinical and diagnostic research
Language(s) - English
Resource type - Journals
eISSN - 2249-782X
pISSN - 0973-709X
DOI - 10.7860/jcdr/2021/48018.14822
Subject(s) - profilometer , cubic zirconia , surface roughness , materials science , surface finish , abutment , implant , composite material , biomedical engineering , dentistry , optics , medicine , surgery , structural engineering , ceramic , physics , engineering
Zirconia is considered as an alternative material for the fabrication of implants. Surface roughness of the implant plays a fundamental role in the initial bone formation. The rationale of using 3D optical profilometry in this study was to evaluate the surface roughness of the zirconia implants before and after Ultraviolet (UV) photofunctionalisation. Also, Moreso 3D optical instruments have a better resolution than the mechanical ones like Atomic Force Microscopy (AFM). Aim: To analyse the surface roughness and topography of zirconia implants after photofunctionalisation using optical profilometry. Materials and Methods: This is an in-vitro study conducted over a period of six months from March 2020 to August 2020. Ten commercially machined Zirconia implants, five each in study and control group, were micro analysed at three different regions (abutment, thread and crest) by optical profilometry. Study group was surface treated by UV radiation for 48 hours. Quantitative morphometric analysis was done between two groups and p-value less than 0.05 was considered statistically significant. The statistical test applied in this study was independent t-test. Results: Scanning micrographs of the study group revealed highest density of summits contributing to increased surface area in the study group. Quantitative analysis of surface roughness showed statistically significant higher mean roughness parameter for photofunctionalised implants in abutment, crest and thread region (p<0.05). Conclusion: Photofunctionalisation is a potentially synergistic technique in producing textured zirconia implants.