Open AccessIDENTIFICATION OF RHEOLOGICAL PROPERTIES OF POLY(ETHYLENE OXIDE) – WATER SOLUTIONS
Author(s) -
Ryszard Wójtowicz,
Katarzyna Kocewiak,
А. А. Липин
Publication year - 2020
Publication title -
izvestiâ vysših učebnyh zavedenij. himiâ i himičeskaâ tehnologiâ/izvestiâ vysših učebnyh zavedenij. seriâ himiâ i himičeskaâ tehnologiâ
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.221
H-Index - 5
eISSN - 2500-3070
pISSN - 0579-2991
DOI - 10.6060/ivkkt.20206309.6236
Subject(s) - rheology , thermodynamics , shear thinning , ethylene oxide , materials science , shear rate , non newtonian fluid , viscometer , newtonian fluid , chemistry , viscosity , composite material , polymer , copolymer , physics
In the paper results of investigations of rheological properties for selected PEO-water solutions are presented. On the basis of measurements, carried out with use of rotational viscosimeter values of shear stresses were determined in the relatively wide range of shear rates. Rheological curves were described by the Ostwald de Waele model (or so-called power-law). The model coefficients such as the fluid consistency coefficient k and the flow behavior index n were determined using Levenberg−Marquardt algorithm for nonlinear estimation. The influence of temperature on properties and behavior examined non-Newtonian fluids was also determined. Results were processed in the curve shift parameter at. Experiments shown a significant effect of poly(ethylene oxide) concentration cPEO on rheological properties of examined solutions. For the lowest concentration (cPEO=1.2%) solutions exhibited properties similar to Newtonian fluids with values of n close to 1. With increasing of PEO concentration in water (cPEO=2.4-4.8%), solutions exhibited properties as non - Newtonian fluids, pseudoplastic, without yield limit. In these cases values of n were below unity and for the highest concentration (cPEO=4.8%) belonged to the range of n=0.5694-0.7536, depending on the temperature. Results of investigations can be used during numerical simulations, design and optimization of industrial equipment, working with fluids of this kind, including mixing vessels, columns or heat exchangers.