Open AccessMulti Response Optimization of Process Parameters in Drilling Operation for Jute and Basalt Fabric Composite Material
Author(s) -
M. Indira Rani,
A. Ramesh,
K. Ramu,
N.V. Srinivasulu
Publication year - 2019
Publication title -
international journal of engineering and advanced technology
Language(s) - English
Resource type - Journals
ISSN - 2249-8958
DOI - 10.35940/ijeat.a9380.109119
Subject(s) - taguchi methods , surface roughness , delamination (geology) , materials science , composite material , orthogonal array , drill , response surface methodology , drill bit , drilling , machining , design of experiments , surface finish , mechanical engineering , engineering , computer science , mathematics , metallurgy , geology , paleontology , statistics , machine learning , subduction , tectonics
Natural fabric Reinforced polymer (NFRP) composites are the materials by a matrix and a reinforcement of natural fibre. NFRPs are the materials with low density, high molding flexibility, environmentally friendly and have wide range of applications extending from products of commodity to aerospace, defence, automobile spare parts, and bicycle frames applications. In this work the effect of cutting parameters in drilling Natural fabric reinforced composites were studied. Experiments were conducted to study the effect of drill bit diameter, spindle speed and feed rate on Material Removal Rate (MRR), Surface Roughness, Circularity of Hole and Delamination Factor. Theoretical calculations are done to calculate Material Removal Rate and Delamination Factor. Surface Roughness and Circularity of Hole measured by Surface Roughness Tester and Coordinate Measuring Machine (CMM) respectively. The input parameters considered were 6mm, 8mm and 10mm diameter drill bits, spindle speeds of 600rpm, 1200rpm & 1800rpm, feed rates of 0.1rev/min, 0.2rev/min and 0.3rev/min. Experiments were carried as per Taguchi Experimental Design (L9) to get the optimum values of MRR, Surface Roughness, And Circularity Of Hole and Delamination Factor. Optimization was done using Taguchi Analysis, Grey Taguchi Analysis and Multi Attribute Decision Making (MADM) Method. The optimal solution for the multiple response system of drilling of NFRP were diameter of drill bit of 10 mm, Spindle speed 600 rpm and at 0.3 mm/rev feed rate. MADM process concluded that, Circularity of Hole was most preferred response than followed by Material Removal Rate, Surface Roughness and Delamination Factor.