Open AccessSimulation of wire and arc additive manufacturing of 308L stainless steel with cold arc gas metal arc welding
Author(s) -
Nur Izan Syahriah Hussein,
Nur Aisyah Nabilah Mohd Jmmani,
Mohamad Nizam Ayof,
Toibah Abd Rahim,
Muhammad Zaimi Zainal Abidin,
Farazila Yusof,
Mohd Fadzil Jamaludin,
Stewart Williams
Publication year - 2021
Language(s) - English
DOI - 10.24191/jaeds.v1i1.35
Subject(s) - gas metal arc welding , welding , materials science , metallurgy , taguchi methods , arc (geometry) , voltage , heat affected zone , composite material , mechanical engineering , engineering , electrical engineering
This research focuses on the capabilities of coldArc GMAW in the behavior of heat input to the weld bead dimension. In this study, the effect of process GMAW of 308L stainless steel filler wire with a thickness of 1.2 mm and 304L stainless steel base plate, with a dimension of 120 mm x 25 mm x 10 mm (height x width x thickness) by applying WAAM. The data was collected using MATLAB of a Smart Weld Rosenthal’s Steady-State 3D Isotherms. A Taguchi response was used in the DOE method with Minitab software to analyze the effect of process parameters on height, width, and depth of weld bead dimension during GMAW. The experiments were conducted following the low, mid, and high input parameters will show the different structures of weld bead dimension, which include 70 A, 75 A, and 78 A (arc current), 15 V, 16 V, and 17 V (voltage), 400 mm/min, 600 mm/min, and 800 mm/min (welding speed). Hence, the optimum value is 75 A, 16 V, and 800 mm/min, and the most significant parameters to deposit stainless steel with coldArc GMAW were welding speed followed by arc current and voltage.