Open AccessTHERMAL CHANGES OBSERVED AT DRILLING SITE DURING BONE DRILLING Model study in bovine rib
Author(s) -
Dedy Kusuma
Publication year - 2011
Publication title -
jurnal teknosains: jurnal ilmiah sains dan teknologi/jurnal teknosains : jurnal ilmiah sains dan teknologi
Language(s) - English
Resource type - Journals
eISSN - 2443-1311
pISSN - 2089-6131
DOI - 10.22146/teknosains.3985
Subject(s) - drilling , drill , thermocouple , materials science , drill bit , rib cage , rotational speed , composite material , biomedical engineering , structural engineering , mechanical engineering , metallurgy , engineering
The use of bone drill in the process of odontectomy and preparation of dental implant may increase temperature around drilling hole. As thermal changes are the critical precursor to physiological bone healing, increased of temperature over threshold must be minimized. The aim of this model study was to compare the temperature changes that were generated during bone drilling with various speeds. Eighteen fresh bovine ribs were chosen due to the similarity of physical properties and dimension of human mandible. A constant drill load of 4.06N was applied throughout the drilling procedures via a drilling rig. Bovine ribs were drilled by using the same bur geometry (twist drill, 120 point angle) at low speed (8.750 rpm, 21.875 rpm, 35.000 rpm). The bone temperature changes generated by the drilling process were measured measured by K-type thermocouple. The speed of 8750 rpm produced a maximum temperature changes in both distance of 1 mm and 2 mm from drilling hole. Minimal temperature changes were recorded for the speed of 35.000 rpm. ANOVA test, showed the mean of thermal changes for each of speed at distance 1 and 2 mm from drilling hole. The clinical benefits of using speed below 35000 rpm need to be considered due to the potential risk of thermal damage.