z-logo
Premium
Woodchip Denitrification Bioreactors: Impact of Temperature and Hydraulic Retention Time on Nitrate Removal
Author(s) -
Hoover Natasha L.,
Bhandari Alok,
Soupir Michelle L.,
Moorman Thomas B.
Publication year - 2016
Publication title -
journal of environmental quality
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.888
H-Index - 171
eISSN - 1537-2537
pISSN - 0047-2425
DOI - 10.2134/jeq2015.03.0161
Subject(s) - denitrification , hydraulic retention time , nitrate , environmental science , bioreactor , retention time , environmental engineering , nitrogen , chemistry , wastewater , chromatography , organic chemistry
Woodchip denitrification bioreactors, a relatively new technology for edge‐of‐field treatment of subsurface agricultural drainage water, have shown potential for nitrate removal. However, few studies have evaluated the performance of these reactors under varied controlled conditions including initial woodchip age and a range of hydraulic retention times (HRTs) and temperatures similar to the field. This study investigated (i) the release of total organic C (TOC) during reactor start up for fresh and weathered woodchips, (ii) nitrate (NO 3 –N) removal at HRTs ranging from 2 to 24 h, (iii) nitrate removal at influent NO 3 –N concentrations of 10, 30, and 50 mg L −1 , and (iv) NO 3 –N removal at 10, 15, and 20°C. Greater TOC was released during bioreactor operation with fresh woodchips, whereas organic C release was low when the columns were packed with naturally weathered woodchips. Nitrate‐N concentration reductions increased from 8 to 55% as HRT increased. Nitrate removal on a mass basis (g NO 3 –N m −3 d −1 ) did not follow the same trend, with relatively consistent mass removal measured as HRT increased from 1.7 to 21.2 h. Comparison of mean NO 3 –N load reduction for various influent NO 3 –N concentrations showed lower reduction at an influent concentration of 10 mg L −1 and higher NO 3 –N reductions at influent concentrations of 30 and 50 mg L −1 . Nitrate‐N removal showed a stepped increase with temperature. Temperature coefficient ( Q 10 ) factors calculated from NO 3 –N removal rates ranged from 2.2 to 2.9. Core Ideas The results are useful for informing field‐specific design of denitrification woodchip bioreactors. Nitrate‐N concentration reductions increased from 8 to 55% as hydraulic retention time increased. Nitrate‐N removal showed a stepped increase with temperature. Weathered woodchips as a bioreactor substrate may reduce initial C losses to surface waters.

This content is not available in your region!

Continue researching here.

Having issues? You can contact us here