Phosphate Adsorption by Ferrihydrite‐Amended Soils

New technology and approaches for reducing P in runoff from high sediment yield areas are essential due to implementation of increasingly rigorous water quality standards. The objectives of this research were to characterize ferrihydrite (Fe 5 HO 8 ·4H 2 O) in terms of its ability to adsorb P from soil solutions and relate its P adsorptive capacity to several soil properties that influence P mobility. A naturally occurring ferrihydrite, collected as an Fe oxide sludge by‐product from a water treatment facility, was equilibrated with soil samples at equivalent rates of 0, 0.34, 3.36, 16.80, and 33.60 Mg ha −1 for a 60‐d period. Individual 2‐g subsamples of each soil were then equilibrated with 0, 5, 10, 20, and 40 mg kg −1 P in 20 mL of 0.01 M CaCl 2 on a reciprocating shaker for 24 h. After 24 h, P in solution was measured by colorimetric methods, and designated as final P concentrations. The data indicated that the unamended soils with a pH of <6.0 adsorbed, in some cases, 50 times more P than soils with a pH of >7.0. The final P concentrations, averaged for all initial P concentrations and ferrihydrite rates, ranged from 0.09 to 4.63 mg kg −1 , and were most highly correlated with pH ( r = 0.844; P ≤ 0.01), oxalate‐extractable Fe ( r = −0.699; P ≤ 0.10), and dithionite‐extractable Fe ( r = −0.639; P ≤ 0.10) contents of the unamended soils. In terms of individual soils, correlation coefficients ( r ) for final P concentrations versus ferrihydrite amendment rates indicated a statistically significant ( P ≤ 0.001) negative relationship at all initial P concentrations for most A horizons. The r values for the high Fe oxide content B horizon soils did not show a statistically significant response to ferrihydrite additions. The results indicate that P adsorption, in soils amended with ferrihydrite, will be greatest under acid pH conditions below the ferrihydrite zero point of charge (pH 5.77), and low incipient Fe oxide contents.