Open AccessDetermination of the maximum dangerous width of a rail track on a reinforced concrete base with fasteners of the КБ type, taking into account all influencing factors
Author(s) -
V N Novikov,
Andriy Babenko,
Oleksandr Kharkivskyi,
Olena Olexandrivna Tkachenko
Publication year - 2021
Publication title -
zbìrnik naukovih pracʹ ukraïnsʹkoï deržavnoï akademìï zalìzničnogo transportu/zbìrnik naukovih pracʹ
Language(s) - English
Resource type - Journals
eISSN - 2413-3795
pISSN - 1994-7852
DOI - 10.18664/1994-7852.197.2021.248306
Subject(s) - track (disk drive) , structural engineering , base (topology) , stock (firearms) , thread (computing) , computer science , engineering , mathematics , mechanical engineering , mathematical analysis
Railway track retention standards in Ukraine do not take into account theconstruction of the subrail base, but regulate one for all types maximum dangerous value of the trackwidth, which was changed from 1546 mm to 1548 mm without any justification of scientific researchor explanations of the effects of tolerances the width of the rail track and the wheel track, which ingeneral at that time were not fully investigated but taking into account the emergence anddevelopment of new scientific problems associated with the emergence of intensive lateral wear ofrails and ridges of locomotive and wagon wheels. The deterministic dependences of lateralimpressions of the P65 type rail thread head on the simultaneous influence of vertical and horizontalforces for the newly installed repair profiles of UZ rolling stock on the basis of previously performedexperimental and theoretical studies were investigated. The results allow at this stage of research todetermine and calculate the practical values of the maximum dangerous width of the track, in whichthe subrail base consists of reinforced concrete sleepers and separate rail fasteners, which are usedboth on conventional highways with mixed traffic and on high-speed lines UZ.The article establishes the need to take into account new factors influencing the dangerouswidth of the rail track with intermediate rail fasteners of separate type depending on the load stress of sections and new repair profiles of rolling stock, as well as wear processes of intermediate railfasteners type KБ and its elements on the appearance of elastic backlash in the lateral direction fromthe influence of the guide wheels of the rolling stock. The recommended value of the maximum widthof the rail track for areas where service or emergency braking is applied - 1550 mm, taking intoaccount that the contact of the wheel and the rail is not at a point, but on an ellipse. The establishednorm of the maximum width of a rail track allows to define economic efficiency of introduction in theconditions of operation of a track in curved sections of a track of small radii with limited use of themaximum admissible lateral wear (15 mm) of a head of a rail thread provided that the normal-forcedentry of rolling stock carts.