Open AccessEvaluation of surface asperities and tool wear after turning with use of a focus variation microscope
Author(s) -
Michał Mendak,
Michał Wieczorowski,
Karol Grochalski,
Bartosz Gapiński
Publication year - 2018
Publication title -
mechanik
Language(s) - English
Resource type - Journals
ISSN - 0025-6552
DOI - 10.17814/mechanik.2018.8-9.115
Subject(s) - carbide , insert (composites) , materials science , surface finish , surface roughness , focus (optics) , metallurgy , scanning electron microscope , mechanical engineering , composite material , engineering , optics , physics
The authors examined the shaft machined in 100Cr6 steel with four different feeds per revolution using round carbide inserts. After each session, the insert was subjected to measurement, and, finally, roughness of the entire shaft was measured. The obtained results were then analyzed and the roughness and wear data of the tools were presented.