Open AccessDECAY OF SUPERCOOLED AUSTENITE OF LOW-CARBON PIPE STEEL WITH THE USE OF GLEEBLE 3500 COMPLEX
Author(s) -
П. П. Полецков,
С. В. Денисов,
О. А. Никитенко,
Д. М. Чукин,
Marina S. Gushchina
Publication year - 2019
Publication title -
izvestiâ vysših učebnyh zavedenij. černaâ metallurgiâ
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.3
H-Index - 7
eISSN - 2410-2091
pISSN - 0368-0797
DOI - 10.17073/0368-0797-2019-3-235-240
Subject(s) - bainite , austenite , metallurgy , materials science , martensite , ferrite (magnet) , microstructure , carbon fibers , continuous cooling transformation , cementite , carbon steel , supercooling , composite material , thermodynamics , corrosion , composite number , physics
The promising direction in improving the strength properties of low-carbon steels is the use of controlled rolling providing formation of structures with prevalence of a bainite component. Analysis of the references has shown that now there are no detailed researches which allow to approve what morphological type of bainite provides the most optimal properties. In this regard in the present work the influence of cooling rate on the structure, properties, and structuralphase transformations of low-carbon complex-alloyed pipe steel containing 0.062 % C; 1.80 % Mn; 0.12 % Mo; 0.032 % Cr, 0.90 % Ni and other elements (Al, Cu, V, Nb, Ti) was studied. The dilatometric method was used to construct the CCT diagram of the decay of supercooled austenite of low-carbon complex-alloyed pipe steel. The qualitative and quantitative analysis of microstructure was carried out and hardness after various speeds of cooling was determined. There were identified the cooling rates providing bainite structures and increase in the strength properties of steel with specified composition. At a cooling rate since 0.05 to 6 °C/s, along with ferrite, a globular bainite is formed in the microstructure, consisting of bainitic α-phase and “islands” of martensite-austenite component ranging in size from 1 – 6 μm. At a cooling rate of 6 °C/s, conversion to reed bainite is observed, along with the borders of which the carbides and residual austenite are located. At cooling rates of more than 16 °C/s, bainite becomes bag-rack. With an increase in cooling rate from 50 to 150 °C/s, the average width of the bainite α-phase rails decreases from 2.22 to 1.32 μm.