Open AccessDEFORMATION BEHAVIOR MATHEMATICAL MODELING OF A POLYMER MATERIAL LAYER WITH TECHNOLOGICAL HOLE FOR A LUBRICANT
Author(s) -
A. A. Kamenskih,
AUTHOR_ID,
Veronica Strukova,
AUTHOR_ID
Publication year - 2021
Publication title -
prikladnaâ matematika i voprosy upravleniâ
Language(s) - English
Resource type - Journals
eISSN - 2782-4500
pISSN - 2499-9873
DOI - 10.15593/2499-9873/2021.2.02
Subject(s) - materials science , lubricant , contact area , deformation (meteorology) , indentation , rounding , mechanics , radius , composite material , lubrication , work (physics) , contact mechanics , structural engineering , mechanical engineering , engineering , finite element method , computer science , physics , computer security , operating system
Mathematical modeling of the flat layer of a polymeric material deformation behavior with a polished steel plate within the framework frictional contact was carried out of this work. The influence of the technological groove geometric configuration for the lubricant on the contact unit deformation is considered. The lubricant volume in the calculation scheme does not take into account that does not correspond to the favorable occasion of lack of lubrication in the recess. The parameterized model creation of a polymer layer portion with one technological recess with a different base rounding radius from 0.5 to 2 mm with a step of 0.25 mm is done. The technological recess geometrical influence on the deformation of its profile at loads from 5 to 90 MPa was established within the framework of the study. Changes in the cross-sectional area of the recess, the maximum level of the plastic deformations intensity, contact pressure, contact tangential stress and the contact interaction area from the load and the rounding radius are established. The contact zone parameters redistribution due to an increase in the contact interaction area for all rounding versions for the technological recess base for the lubricant occurs at loads of more than 40-50 MPa. The design with a rounding radius of 2 mm has a number of advantages: minimum deformation of the technological recess area, the minimum level of the maximum plastic deformations intensity, the maximum contact interaction area, etc.