Premium
Measurements of Repeated Tightening and Loosening Torque of Seven Different Implant/Abutment Connection Designs and Their Modifications: An In Vitro Study
Author(s) -
Butkevica Alena,
Nathanson Dan,
Pober Richard,
Strating Herman
Publication year - 2018
Publication title -
journal of prosthodontics
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.902
H-Index - 60
eISSN - 1532-849X
pISSN - 1059-941X
DOI - 10.1111/jopr.12467
Subject(s) - abutment , torque , connection (principal bundle) , implant , structural engineering , orthodontics , dentistry , materials science , computer science , engineering , medicine , physics , surgery , thermodynamics
Purpose Repeated tightening and loosening of the abutment screw may alter its mechanical and physical properties affecting the optimal torque and ultimate reliability of an implant/abutment connection. The purpose of this study was to evaluate the effect of repeated tightening and loosening of implant/abutment screws on the loosening torque of implant/abutment connections of commercially available implant systems. Materials and methods Seven different implant/abutment connections and their modifications were tested. The screws of each system were tightened according to the manufacturer's specifications. After 20 minutes the screws were loosened. This procedure was repeated ten times, and the differences between the 1st and 10th cycle were expressed as a percentage change RTq(%) and correlated with initial torque, the number of threads, the length of shank, and thread surface area employing Spearman's analysis. Results All systems showed significant differences in residual torque (RTq) value ( p < 0.05) between the 1st and 10th cycle except groups 6 and 11 ( p > 0.05). All connections but group 3 ( p = 1.000) showed a significant change from the initial torque (ITq) to the RTq values. The first successive RTq values increased in two connection groups 1 and 2. The remaining connections showed reduced RTq values ranging from –1.2 % (group 5) to –23.5% (group 6). The RTq values declined gradually with every repeated tightening in groups 1, 2, 3, 8, 9, 11, 12. In group 2, after the tenth tightening the RTq was still above the ITq value. Only length of shank demonstrated a correlation with the RTq(%) change over the successive tightening loosening cycles ( p < 0.05). Conclusion Repeated tightening and loosening of implant/abutment screws caused varying torque level changes among the different systems. These observations can probably be attributed to connection design. Clinical Implications : Limiting the number of tightening/loosening cycles in clinical and laboratory procedures is advisable for most of the implant systems tested.