Premium
Curing‐Dependent Changes in Color and Translucency Parameter of Composite Bleach Shades
Author(s) -
PARAVINA RADE D.,
ONTIVEROS JOE C.,
POWERS JOHN M.
Publication year - 2002
Publication title -
journal of esthetic and restorative dentistry
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.919
H-Index - 60
eISSN - 1708-8240
pISSN - 1496-4155
DOI - 10.1111/j.1708-8240.2002.tb00516.x
Subject(s) - curing (chemistry) , bleach , composite material , materials science , composite number , color difference , polymerization , resin composite , chemistry , polymer , organic chemistry , filter (signal processing) , computer science , computer vision
ABSTRACT: Purpose: The goal of this study was to evaluate curing‐dependent changes in color and translucency parameter (TP) values of composite bleach shades. Materials and Methods: Thirty bleach shades of microhybrid and microfill composites were analyzed. Specimens (n = 5) were made as disks, 10 mm in diameter and 2 mm thick, using cylindrical molds. Specimens were polymerized for 60 seconds using a light‐curing unit. Data were collected before and after composite curing using a spectrophotometer and analyzed using the appropriate color‐difference metric equations. Results: L*a*b* ranges (maximum minus minimum values) for microhybrids were 17.7, 2.91, and 7.97, respectively. Corresponding ranges for microfills were 14.4,1.26, and 4.27, respectively. Curing‐dependent color differences varied from 3.7 to 12.0 δE* units, whereas TP values of cured resin composites varied from 2.0 to 7.1. Light‐curing caused increase of microhybrid TP values (+0.7) and decrease of microfill TP values (‐0.7). Color differences were found to be acceptable for five of six composite pairs of the same shade designation (each of them made by the same manufacturer) in post‐curing measurements against white background. CLINICAL SIGNIFICANCE: Curing‐dependent color and TP changes indicate that dentists should use cured composite for matching of shade and translucency. Tested materials became less saturated, with microhybrids becoming darker and microfills becoming lighter after polymerization. Light‐curing caused an increase in translucency of microhybrids and a reduced translucency in microfills.