Premium
Influence of Low‐Temperature Environmental Exposure on the Mechanical Properties and Structural Stability of Dental Zirconia
Author(s) -
Alghazzawi Tariq F.,
Lemons Jack,
Liu PerngRu,
Essig Milton E.,
Bartolucci Alfred A.,
Janowski Gregg M.
Publication year - 2012
Publication title -
journal of prosthodontics
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.902
H-Index - 60
eISSN - 1532-849X
pISSN - 1059-941X
DOI - 10.1111/j.1532-849x.2011.00838.x
Subject(s) - materials science , cubic zirconia , composite material , ceramic
Purpose: The effect of dental fabrication procedures of zirconia monolithic restorations and changes in properties during low‐temperature exposure in the oral environment is not completely understood. The purpose of this study was to investigate the effect of procedures for fabrication of dental restorations by low‐temperature simulation and relative changes of flexural strength, nanoindentation hardness, Young's modulus, surface roughness, and structural stability of yttria‐stabilized zirconia. Materials and Methods: A total of 64 zirconia specimens were prepared to simulate dental practice. The specimens were divided into the control group and the accelerated aging group. The simulated group followed the same procedure as the control group except for the aging treatment. Atomic force microscopy was used to measure surface roughness. The degree of tetragonal‐to‐monoclinic transformation was determined using X‐ray diffraction. Nanoindentation hardness and modulus measurements were carried out on the surface of the zirconia specimens using a nanoindenter XP/G200 system. The yttria levels for nonaged and aged specimens were measured using energy dispersive spectroscopy. Flexural strength was determined using the piston‐on‐three‐ball test. The t ‐test was used to determine statistical significance. Results: Means and standard deviations were calculated using all observations for each condition and evaluated using a group t ‐test ( p < 0.05). The LTD treatment resulted in increased surface roughness (from 12.23 nm to 21.56 nm for Ra and 15.06 nm to 27.45 nm for RMS) and monoclinic phase fractions (from 2% to 21%), with a concomitant decrease in hardness (from 16.56 GPa to 15.14 GPa) and modulus (from 275.68 GPa to 256.56 GPa). Yttria content (from 4.43% to 4.46%) and flexural strength (from 586 MPa to 578 MPa) were not significantly altered, supporting longer term in vivo function without biomechanical fracture. Conclusion: The LTD treatment induced the tetragonal‐to‐monoclinic transformation with surface roughening in zirconia prepared using dental procedures.