Lithological stratification in supraglacial sediments: an example from western Tasmania, Australia

Pebble counts of the lithology of glacial sediments in the King Valley show that the content of distantly derived erratics of many sections decreases upwards in near surface sediments. Two factors that contribute to this lithological stratification are dilution of the erratic content of surface sediments by locally derived rocks and lithological stratification of debris within the Pleistocene King Glacier. The common diluting mechanism appears to have been slope detritus derived from the valley sides and small hills that crop out on the valley floor. Lithological stratification of debris in the King Glacier resulted from the altitude of the equilibrium line of the King Glacier relative to the position and altitude of the rock source areas and the thermal regime at the ice‐bed interface. The Jurassic dolerite and Permian sediments that crop out above the equilibrium line altitude were transported in subglacial and englacial positions. In contrast, below the equilibrium line sediments that accumulated and were transported in a supraglacial position contained no erratic lithologies. When deposited, the supraglacial sediments formed a siliceous, non‐erratic cover over sediments that were transported in subglacial and englacial positions. The model of the mode of sediment transport in the King Valley may have application to areas of alpine glaciation where the distribution of some rock types is restricted to areas above the equilibrium lines of glaciers.