Errata

Around 30% to 40% of total losses of agricultural production in Brazil occurs during harvesting and post harvesting processes. Fruits and vegetables are the major contributor to these high losses. Among them, banana can reach losses up to 40% of total production. The knowledge of mechanical properties of fruits and vegetables is important not only for better designing of handling equipment but also to improve quality management as well as shelf life. This work reports the development of a methodology to evaluate the mechanical damage of banana fruit during manual transportation. It was measured the contact area between shoulder and fruit, accelerations during manual transportation on irregular topography on grass and concrete surfaces. Mechanical tests of penetration, compression and cyclic compression between parallel rigid plates were also performed. Results brought into evidence the high sensitivity of green banana fruits to mechanical loads. Damages in the peduncle were not observed after manual transportation. Values of acceleration between 0,15 and 1,35 g (g=9,8ms) were measured indicating significant additional load to the weight of the bunch during transportation. Compressions using increasing loads did not produce bruise areas correlated to load values revealing that bruise area is not a good indicator of the magnitude of the applied load. Simple compression between flat plates reveled the presence of bio-yielding and different mechanical resistance in whole fruits grown in the upper, medium and lower part of the bunch. Cyclic compression showed that repeated loads of even of small amplitudes may promote permanent changes in mechanical behavior of the tissues with great possibility of damaging them. It was concluded that mechanical damages are present during manual transportation and solutions for protection of the bunch and development of transportation aids are desirable to reduce those damages.