Premium
Investigation into relative slip during fretting fatigue under partial slip contact condition
Author(s) -
SABELKIN V.,
MALL S.
Publication year - 2005
Publication title -
fatigue and fracture of engineering materials and structures
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.887
H-Index - 84
eISSN - 1460-2695
pISSN - 8756-758X
DOI - 10.1111/j.1460-2695.2005.00918.x
Subject(s) - fretting , slip (aerodynamics) , materials science , finite element method , titanium alloy , slip line field , metallurgy , composite material , alloy , structural engineering , engineering , dislocation , aerospace engineering
A finite element analysis based methodology was developed to compute local relative slip on contact surface from the measured global relative slip away from contact surface. A set of springs was included in finite element model to simulate fretting fatigue test system. Compliance of springs was calibrated by comparing experimental and computed global relative slips. This methodology was then used to investigate local relative slip during fretting fatigue in cylinder‐on‐flat contact configuration under partial slip contact condition for unpeened and shot‐peened titanium alloy, Ti–6Al–4V. Relative slip on contact surface is significantly smaller (about one order) than the measured global relative slip by using a conventional extensometer near the contact surface. Effects of coefficient of friction, rigidity of fretting fatigue system and applied stress to specimen on the global and local relative slips were characterized. Coefficient of friction and contact load have considerable effect on local relative slip, and practically no effect on global relative slip. Gross slip condition can develop at some locations on contact surface in spite of overall partial slip condition. Increase in rigidity of fretting fatigue system increases local relative slip but decreases global relative slip. Finally, fatigue life diagrams based on relative slip on contact surface are established for both unpeened and shot‐peened titanium alloy. These show the same characteristics as of the conventional S – N diagram where fatigue life decreases with increase of relative slip.