Premium
A comparison of the microstructure of silicon nitride‐silicon carbide composites made with and without deoxidized starting material
Author(s) -
TURAN S.,
KNOWLES K. M.
Publication year - 1995
Publication title -
journal of microscopy
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.569
H-Index - 111
eISSN - 1365-2818
pISSN - 0022-2720
DOI - 10.1111/j.1365-2818.1995.tb03560.x
Subject(s) - materials science , composite material , microstructure , silicon carbide , composite number , silicon nitride , grain boundary , amorphous solid , intergranular corrosion , carbide , silicon , silicide , transmission electron microscopy , metallurgy , layer (electronics) , nanotechnology , crystallography , chemistry
Summary Two different types of silicon carbide (SiC) matrix composites, with either 10 wt% or 20 wt% silicon nitride (Si 3 N 4 ) reinforcement, were fabricated to investigate the effect of pretreatment on the resulting composite micro‐structure. The first type of composite was prepared from as‐received α‐SiC and α‐Si 3 N 4 powders, while the second type was prepared from powder compacts that had been deoxidized to eliminate surface silica on the powder particles. The composites were hot isostatically pressed in tantalum cans at 2373 K for 1h under a pressure of 200 MPa. Density measurements showed that full theoretical density was achieved for the composites prepared from the as‐received powders, while much lower densities were obtained for the composites prepared from the deoxidized green compacts. Almost all of the α‐SiC transformed into β‐SiC, and almost all the α‐Si 3 N 4 transformed into α‐Si 3 N 4 in the composites made from the as‐received powders, while in the composites made from the deoxidized material the α‐SiC remained untransformed and both α‐Si 3 N 4 and β‐Si 3 N 4 phases were present in significant quantities. High‐resolution transmission electron microscopy and Fresnel fringe imaging were used to identify the grain boundary and interphase boundary structure. Most interfaces were found to be covered with ≅ 1 nm thick amorphous intergranular films in the composites prepared from as‐received powders, whereas most interfaces were found to be free of such amorphous intergranular films in the composites prepared from the deoxidized material. Taken together, the presence of intergranular films at the interfaces and the results from density measurements are consistent with the densification and reverse α → β‐SiC transformation taking place in the composites made from as‐received powders by a liquid‐phase sintering route. An incomplete liquid‐phase sintering mechanism is also able to explain the microstructure observed in the composites made from the deoxidized material.