Premium
Nucleation and Growth of Diamond Films on Ni‐Cemented Tungsten Carbide: II, Effects of Deposition Conditions
Author(s) -
Polini Riccardo,
Marcheselli Giancarlo,
Mattei Giorgio,
Traversa Enrico
Publication year - 1995
Publication title -
journal of the american ceramic society
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.9
H-Index - 196
eISSN - 1551-2916
pISSN - 0002-7820
DOI - 10.1111/j.1151-2916.1995.tb08681.x
Subject(s) - nucleation , diamond , chemical vapor deposition , materials science , crystallinity , raman spectroscopy , chemical engineering , scanning electron microscope , annealing (glass) , tungsten carbide , tungsten , substrate (aquarium) , analytical chemistry (journal) , mineralogy , metallurgy , nanotechnology , composite material , chemistry , physics , oceanography , organic chemistry , engineering , chromatography , geology , optics
Diamond films were deposited by hot‐filament chemical vapor deposition (HFCVD) on substrates made of WC sintered with 6 wt% of Ni. The as‐ground substrates were scratched with diamond powder (S samples) or scratched and wet‐etched (SE samples). Diamond synthesis was carried out at substrate temperatures ranging between 600° and 1050°C, and using 1.0% or 2.0% CH 4 in H 2 . The diamond nucleation density, as measured by scanning electron microscopy (SEM) and automatic image analysis (AIA), did not significantly change in the 600°‐900°C temperature range, while at substrate temperatures higher than 900°C a steep decrease of the density of nuclei was observed and attributed to the thermal annealing of nucleation sites. The activation energy of the growth process was measured and found to be 21 ± 2 kcal/mol. Neither nucleation density nor growth rate were affected by an increase of CH 4 concentration in the feed gas, while a lack of crystallinity was observed at the higher methane concentration. Raman analysis showed that phase purity of the films was affected mainly by the substrate temperature: the lower the temperature, the better the film quality. The presence of Ni on the substrate surface did not induce the preferential formation of non‐diamond carbon phases, as confirmed by comparing the Raman spectra obtained from both S and SE substrates. As a comparison, continuous films were deposited on scratched WC‐5 wt% Co substrates under the same experimental conditions. The results indicated that the use of Ni as a binder is preferable to Co.