Premium
Mechanism of Material Removal from Silicon Carbide by Carbon Dioxide Laser Heating
Author(s) -
DeBastiani Duane L.,
Modest Michael F.,
Stubican Vladimir S.
Publication year - 1990
Publication title -
journal of the american ceramic society
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.9
H-Index - 196
eISSN - 1551-2916
pISSN - 0002-7820
DOI - 10.1111/j.1151-2916.1990.tb05250.x
Subject(s) - materials science , silicon carbide , scanning electron microscope , microstructure , composite material , groove (engineering) , silicon , metallurgy
The mechanism of material removal from SiC by CO 2 laser heating was studied using sintered and single‐crystal α‐SiC. Removal rate and width of the groove showed maxima when plotted as a function of translation speeds. Groove depth decreased as the translation speed of samples increased. Similar results were obtained if argon or air was used as gas assist, which indicated that the material removal mechanism is induced dissociation of SiC. Microstructure of the material deposited in and outside of the groove was studied by SEM. At low scanning speeds, columnar grains 10 to 50 μm long appeared. As the scanning speed increased, columnar grains became smaller and finally only irregular polycrystalline particles were observed. By using Raman spectroscopy, Auger analysis, and X‐ray diffraction, phases inside and outside the groove were identified as Si, β‐SiC, C, and SiO 2 . Columnar grains were identified as β‐SiC covered with thin layers of C, Si, and SiO 2 . Slow scanning speeds enhanced the growth of β‐SiC. At slow scanning speed, free silicon was always found in the grooves of lased single crystals but not in the grooves of lased sintered SiC. It can be concluded that the mechanism of material removal from silicon carbide by CO 2 laser heating is a vaporization process, and material found in the groove and on the surface near the groove is formed by condensation from the vapor.