Single crystal flake parameters of MoS2 and MoSe2 exfoliated using anodic bonding technique and its potential in rapid prototyping

Rapid prototyping of devices using exfoliated Molybednum di-Sulphide (MoS 2 ) and Molybdenum di-Selenide (MoSe 2 ) requires an experimental protocol for maximizing the probability of realizing flakes with desired physical dimension and properties. In this work, we analyzed the size and thickness distribution of MoS 2 and MoSe 2 single crystalline flakes exfoliated using anodic bonding technique and established a correlation between physical dimension of the flakes and the bonding parameters. Anodic bonding was carried out by applying a fixed voltage of 200 V with a set temperature of 150 °C for four different bonding time intervals. On analyzing the flake parameters from the four anodic bonded substrates using the optical and atomic force microscopy, it is found that the probability of getting flakes with large lateral size (>200 μ m) increases as the bonding time interval is increased. Most of these large sized flakes have thickness of more than one hundred mono-layers and a tiny fraction of them have thickness of the order of few monolayers. A similar trend was also observed for MoSe 2 single crystals. To demonstrate the feasibility of this technique in rapid prototyping, ultra thin MoS 2 flakes was directly bridged between two ITO electrodes and their transport properties was investigated. Micro-Raman and photoluminescence studies were taken on selected regions of the thicker and thinner exfoliated flakes and their physical properties are compared.