Open AccessTechnological Rule of Ultrasonic Assisted Magnetic Abrasive Finishing of Titanium Alloy
Author(s) -
Tianliang Jiang,
X Liu,
Y Liu,
S F Zhang,
Zhihua Sha
Publication year - 2019
Publication title -
iop conference series. materials science and engineering
Language(s) - English
Resource type - Journals
eISSN - 1757-899X
pISSN - 1757-8981
DOI - 10.1088/1757-899x/616/1/012018
Subject(s) - machining , surface roughness , materials science , ultrasonic machining , surface finish , titanium alloy , ultrasonic sensor , abrasive , metallurgy , composite material , alloy , titanium , acoustics , physics
The influence of machining time, ultrasonic amplitude, spindle speed and machining gap on surface roughness and material removal rate were studied and analysed through the experiment of UAMAF of titanium alloy. The results show that the surface roughness decreases rapidly in the beginning and then gradually stabilizes as the machining time increases. The surface roughness reduces from the original Ra0.94μm to Ra0.10μm, when the machining time reaches 30min that is optimum machining time. The material removal rate drops approximately linearly with the increase of machining time. The surface roughness decreases significantly and the material removal rate increases rapidly as the ultrasonic amplitude rises. The surface roughness reduces to Ra0.12μm and the material removal rate increases to 30.5mg/h, when the ultrasonic amplitude is up to 14μm. The surface roughness decreases in the beginning and then increases, and the material removal rate rises in the beginning and then falls, as the spindle speed increases. The surface roughness achieves a minimum of Ra0.11μm and the material removal rate reaches a maximum of 22.74mg/h, when the spindle speed is 1400r/min. The surface roughness drops in the beginning and then rises, and the material removal rate increases in the beginning and then decreases, as the machining gap enlarges. The optimum machining gap is about 1.25mm. In this case, the surface roughness achieves a minimum of Ra0.16μm, and the material removal rate reaches a maximum of 17.7mg/h.