Open AccessSpringback Behaviour due to Die Deflection during Bending
Author(s) -
Hideo Tsutamori,
Yoshihiko Nakamoto,
Tomoya Nishiwaki
Publication year - 2021
Publication title -
iop conference series. materials science and engineering
Language(s) - English
Resource type - Journals
eISSN - 1757-899X
pISSN - 1757-8981
DOI - 10.1088/1757-899x/1157/1/012034
Subject(s) - deflection (physics) , flexural rigidity , die (integrated circuit) , structural engineering , materials science , bending , composite material , engineering , physics , optics , nanotechnology
The material strength of rolled steel sheet for car bodies is increasing considerably. It has been experientially known that the die deflection affects the springback, but there are few experimental verification cases. In this study, two bending dies with different rigidity but the same shape were manufactured. The springback of panels bended by each die was compared in detail. Using 590MPa class and 980MPa class steel sheets, the deformation of the dies due to bending also measured. The springback and deflection of the die were clearly large using the low rigidity die. From these results, it was suggested that it is necessary to consider the die deflection for accurate springback prediction of bending.