Open AccessNumerical Analyses on the Rockbolt Behaviour in Rock Wedges Reinforcement Using 2D-DDA
Author(s) -
Wenqi Wang,
Wen Nie,
Xu Li,
Shuang Liu
Publication year - 2020
Publication title -
iop conference series. earth and environmental science
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.179
H-Index - 26
eISSN - 1755-1307
pISSN - 1755-1315
DOI - 10.1088/1755-1315/570/2/022042
Subject(s) - wedge (geometry) , geotechnical engineering , discontinuous deformation analysis , overburden pressure , roof , geology , rock mass classification , materials science , structural engineering , engineering , finite element method , geometry , mathematics
One major concern in the design and construction of caverns in jointed rock mass is the potential failure of rock wedges falling from the roof or sliding out from the sidewalls. The rockbolts are commonly used to improve the stability and to prevent failure in the caverns. In this paper, the two-dimensional discontinuous deformation analysis (2D-DDA) method was used to analyse the stability of the rock wedge supported by rockbolts on the cavern roof. The joint relaxation method was adopted to represent a deformable rock joint under stresses. Parametric studies were conducted to investigate the effects of the confining pressure, the spacing and the angle between rockbolt and direction of wedge falling on the stability of the rock wedge. The numerical simulation results indicate that the wedge is self-supporting after stress redistribution if the confining pressure is larger than the critical confining pressure and the semi-apical angle of the wedge is less than the friction angle of rock joint. The force in rockbolt slightly decreases with reduced rockbolts spacing but increase when the rockbolt is not along the falling direction of rock wedge.