Open AccessAn optimization of the machining parameters on delamination in drilling ramie woven reinforced composites using Taguchi method
Author(s) -
Sri Chandrabakty,
Ilyas Renreng,
Zuryati Djafar,
Hairul Arsyad
Publication year - 2019
Publication title -
journal of physics. conference series
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.21
H-Index - 85
eISSN - 1742-6596
pISSN - 1742-6588
DOI - 10.1088/1742-6596/1341/5/052005
Subject(s) - taguchi methods , delamination (geology) , drilling , drill , materials science , drill bit , machining , composite material , ramie , orthogonal array , structural engineering , engineering , geology , fiber , metallurgy , paleontology , subduction , tectonics
In this study, the drilling parameters will be evaluated to obtain optimal parameters in minimizing the impact of drilling damage on composite materials reinforced by ramie woven. The impact of damage observed in the study is delamination that occurs in the drill hole, where the smaller value is desired. The drilling parameters are optimized using the Taguchi method with two control factors, namely the feed rate and spindle speed, each parameter is designed in three levels. This experiment then carried out on four different diameter drill bits, i.e., 4, 6, 8 and 10 mm. While experimental planning uses L 9 orthogonal arrays and the “smaller is better” approach is given as a standard analysis. By performing an analysis of variance (ANOVA) statistics can be determined for the significance of each drilling parameter. A series of experiments were carried out to get the appropriate optimization. It was found that the critical factor causing delamination in drilling is the feed rate followed by spindle speed, where this phenomenon occurs in each diameter of the drill bit.