Premium
Effect of finishing and polishing procedures on the surface roughness of new tooth‐coloured restoratives
Author(s) -
Özgünaltay G.,
Yazici A. R.,
Görücü J.
Publication year - 2003
Publication title -
journal of oral rehabilitation
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.991
H-Index - 93
eISSN - 1365-2842
pISSN - 0305-182X
DOI - 10.1046/j.1365-2842.2003.01022.x
Subject(s) - polishing , materials science , surface roughness , silicone , scanning electron microscope , glaze , diamond , ceramic , composite number , carbide , surface finish , composite material , metallurgy
summary The purpose of this study was to evaluate the effect of various finishing and polishing procedures on the surface roughness of three new tooth‐coloured restorative materials. The materials included a hybrid composite resin (Filtek Z250), a packable composite resin (Filtek P60), and an ormocer (organically modified ceramic) (Definite). Thirty‐two specimens of each material were prepared and randomly divided into four finishing and polishing groups ( n =8): (i) diamond bur/silicone polishers, (ii) diamond bur/Sof‐Lex discs, (iii) carbide bur/silicone polishers, (iv) carbide bur/Sof‐Lex discs. Average surface roughness (Ra) in micrometers was measured with a Mitutoyo Surftest‐402 Surface Roughness Tester and the data compared using anova , at P ≤0·05. Surface topography was also assessed using the scanning electron microscope (s.e.m) from samples of each group. The Mylar strip produced the smoothest surface and finishing/polishing procedures; (ii) and (iv) were significantly smoother than (i) and (iii). The lowest variability in initial surface roughness between materials was also observed with ormocer group.