Premium
Influence of Effective Stress and Pore Fluid Pressure on Fault Strength and Slip Localization in Carbonate Slip Zones
Author(s) -
Rempe Marieke,
Di Toro Giulio,
Mitchell Thomas M.,
Smith Steven A. F.,
Hirose Takehiro,
Renner Joerg
Publication year - 2020
Publication title -
journal of geophysical research: solid earth
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 1.983
H-Index - 232
eISSN - 2169-9356
pISSN - 2169-9313
DOI - 10.1029/2020jb019805
Subject(s) - slip (aerodynamics) , pore water pressure , effective stress , calcite , geology , cabin pressurization , shear (geology) , shear stress , geotechnical engineering , materials science , overburden pressure , pressure solution , composite material , mineralogy , compaction , thermodynamics , physics
The presence of pressurized fluids influences the mechanical behavior of faults. To test the roles of normal stress and fluid pressure on shear strength and localization behavior of calcite gouges, we conducted a series of rotary‐shear experiments with pore fluid pressures up to 10.5 MPa and difference between normal stress and fluid pressure up to 11.2 MPa. Calcite gouges were sheared for displacements of 0.3 m to several meters at slip rates of 1 mm/s and 1 m/s. Drainage conditions in experiments were constrained from estimates of the hydraulic diffusivity. Gouges were found to be drained at 1 mm/s, but possibly partially undrained during sliding at 1 m/s. Shear strength obeys an effective‐stress law with an effective‐stress coefficient close to unity with a friction coefficient of ~0.7 that decreases to 0.19 due to dynamic weakening. The degree of comminution and slip localization constrained from experimental microstructures depends on the effective normal stress. Slip localization in calcite gouges does not occur at low effective normal stress. The presence of pore fluids lowers the shear strength of gouges sheared at 1 mm/s and causes an accelerated weakening at 1 m/s compared to dry gouges, possibly due to enhanced subcritical crack growth and intergranular lubrication. Thermal pressurization occurs only after dynamic weakening when friction is generally low and relatively independent of normal stress and therefore unaffected by thermal pressurization. The experimental results are consistent with the view that the presence of pressurized fluid in carbonate‐bearing faults can facilitate earthquake nucleation.