Amorphous TiCu-Based Additives for Improving Hydrogen Storage Properties of Magnesium Hydride

Magnesium hydride has long been regarded as a promising candidate material for hydrogen and heat storage due to its high hydrogen capacity, reversibility, and low cost. Catalytic doping has been demonstrated as one of the most effective methods to improve hydrogen storage properties of MgH 2 . In this study, amorphous Ti 45 Cu 41 Ni 9 Zr 5 and Ti 40 Cu 47 Zr 10 Sn 3 alloys are used as additives for MgH 2 . Nanostructured MgH 2 doped with amorphous or crystalline TiCu-based alloys are prepared by using a high-energy mechanochemical synthesis method. Results show that the amorphous TiCu additives provide enhanced catalytic effects compared to crystalline alloys of the same composition. Doping MgH 2 using an amorphous Ti 45 Cu 41 Ni 9 Zr 5 alloy yielded improved dehydrogenation kinetics compared to using crystalline Ti 40 Cu 47 Zr 10 Sn 3 alloy. The analysis using transmission electron microscopy reveals that there are nanostructured catalytic particles uniformly distributed in the amorphous TiCu-catalyzed MgH 2 . The MgH 2 system catalyzed by amorphous TiCu-based alloy shows little degradation during hydrogenation and dehydrogenation cycling at 300 °C. The amorphous TiCu-based catalysts are thermally stable at temperatures up to 360 °C. Heating the amorphous Ti 45 Cu 41 Ni 9 Zr 5 -catalyzed MgH 2 o temperatures above 360 °C led to disproportionation of the catalyst alloy and the formation of MgCu 2 and Ti 2 Cu. In addition, PCI analysis of the amorphous Ti 45 Cu 41 Ni 9 Zr 5 -catalyzed MgH 2 shows a slight increase in hydrogen equilibrium pressure, resulting in a reaction enthalpy of -78.7 kJ/mol·H 2 and an entropy of 145.0 J/K·mol·H 2 . The entropy calculated from this study is approximately 10 J/K·mol·H 2 higher than values previously reported for undoped and catalyzed Mg-H systems.