Premium
The rheological modification of talc‐filled polypropylene by epoxy‐polyester hybrid resin and its effect on morphology, crystallinity, and mechanical properties
Author(s) -
Jahani Yousef,
Ehsani Morteza
Publication year - 2009
Publication title -
polymer engineering and science
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.503
H-Index - 111
eISSN - 1548-2634
pISSN - 0032-3888
DOI - 10.1002/pen.21294
Subject(s) - materials science , composite material , polypropylene , epoxy , talc , crystallinity , differential scanning calorimetry , rheology , rheometry , ultimate tensile strength , polyester , crystallization , chemical engineering , physics , engineering , thermodynamics
Abstract Reactive mixing of polypropylene (PP) and talc with epoxy‐polyester resin was preformed using a corotating twin screw extruder, and the rheology, morphology, crystallization behavior, and mechanical properties of composites were evaluated. The melts of composites mixed with resin exhibited yield stress and the variation of viscosity against frequency can be approximated in two lines with various slopes. The measurement of the suspension viscosity can be used to characterize the microstructural state of dispersion. Empirical formula was used to relate viscosity with particle concentration, and the analysis showed that the maximum volume fraction increases by using small amount of epoxy resin in the formulations. The morphological study of composites by scanning electron microscopy revealed that the use of resin improved the dispersion of talc in PP, which leads to the arrangement of talc platelets in the direction of flow even close to wall of the mold. The differential scanning calorimetry showed that the epoxy resin suppressed the nucleation effect of talc on PP while the degree and rate of crystallization increased. The compatibilization by maleic anhydride‐grafted polypropylene showed a noticeable increase in tensile strength of composites reactively mixed with epoxy resin. POLYM. ENG. SCI., 2009. © 2009 Society of Plastics Engineers