Premium
Integration of graphene in poly(lactic) acid by 3D printing to develop creep and wear‐resistant hierarchical nanocomposites
Author(s) -
Bustillos Jenniffer,
Montero Daniela,
Nautiyal Pranjal,
Loganathan Archana,
Boesl Benjamin,
Agarwal Arvind
Publication year - 2018
Publication title -
polymer composites
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.577
H-Index - 82
eISSN - 1548-0569
pISSN - 0272-8397
DOI - 10.1002/pc.24422
Subject(s) - graphene , materials science , polylactic acid , creep , composite material , nanocomposite , tribology , polymer , nanotechnology
Polylactic acid (PLA) and graphene reinforced polylactic acid (PLA‐graphene) composites have been fabricated by three‐dimensional (3D) fused deposition modeling (FDM) printing. Indentation creep resistance was analyzed in terms of the strain‐rate sensitivity index of PLA (0.11) and PLA‐graphene (0.21). Enhanced creep resistance in PLA‐graphene is attributed to the restriction of the polymeric chains by graphene, caused by low strain rates identified during secondary creep. The tribological properties of PLA and PLA‐graphene composites were evaluated by ball‐on‐disk wear tests. Wear resistance was increased by a 14% in PLA‐graphene as compared to PLA. A two‐stage coefficient of friction (COF) behavior has been observed for PLA‐graphene. Initially, PLA‐graphene exhibits a 65% decrease in COF as compared to PLA. During the second stage, PLA‐graphene approached similar COF behavior and value of PLA (∼0.58). PLA‐graphene composites have shown significant improvement in creep and wear resistance demonstrating 3D printing to be a novel manufacturing route. POLYM. COMPOS., 39:3877–3888, 2018. © 2017 Society of Plastics Engineers