Premium
Magnesium tube hydroforming
Author(s) -
Liewald M.,
Pop R.
Publication year - 2008
Publication title -
materialwissenschaft und werkstofftechnik
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.285
H-Index - 38
eISSN - 1521-4052
pISSN - 0933-5137
DOI - 10.1002/mawe.200800303
Subject(s) - formability , hydroforming , materials science , magnesium , metallurgy , elongation , aluminium , ultimate tensile strength , annealing (glass) , magnesium alloy , tube (container) , welding , composite material , die (integrated circuit) , sheet metal , alloy , nanotechnology
Magnesium alloys reveal a good strength‐to‐weight ratio in the family of lightweight metals and gains potential to provide up to 30 % mass savings compared to aluminium and up to 75 % compared to steel. The use of sheet magnesium alloys for auto body applications is however limited due to the relatively low formability at room temperature. Within the scope of this paper, extruded magnesium tubes, which are suitable for hydroforming applications, have been investigated. Results obtained at room temperature using magnesium AZ31 tubes show that circumferential strains are limited to a maximal value of 4 %. In order to examine the influence of the forming temperature on tube formability, investigations have been carried out with a new die set for hot internal high pressure (IHP) forming at temperatures up to 400 °C. Earlier investigations with magnesium AZ31 tubes have shown that fractures occur along the welding line at tubes extruded over a spider die, whereby a non‐uniform expansion at bursting with an elongation value of 24 % can be observed. A maximum circumferential strain of approx. 60 % could be attained when seamless, mechanically pre‐expanded and annealed tubes of the same alloy have been used. The effect of annealing time on materials forming properties shows a fine grained structure for sufficient annealing times as well as deterioration with a large increase at same time. Hence, seamless ZM21 tubes have been used in the current investigations. With these tubes, an increased tensile fracture strain of 116 % at 350 °C is observed as against 19 % at 20 °C, obtained by tensile testing of milled specimens from the extruded tubes. This behaviour is also seen under the condition of tool contact during the IHP forming process. To determine the maximum circumferential strain at different forming temperatures and strain rates, the tubes are initially bulged in a die with square cross‐section under plane stress conditions. Thereafter, the tubes are calibrated by using an optimised pressure‐time curve. The IHP forming process has also been used to demonstrate practicability and feasibility for real parts by manufacturing a technology‐demonstrator part using the magnesium alloy ZM21.