Modern strategies for protein quantification in proteome analysis: Advantages and limitations

I. Introduction 287 II. Sample Preparation 289A. Influence of Alkylation 289B. Influence of Surfactants 289 III. MS‐Based Strategies for Protein Quantification 290A. Isotope‐Coded Affinity Tags (ICAT) 291B. Mass‐Coded Abundance Tagging (MCAT) 293C. Stable Isotope‐Labeling of Proteins/Peptides 294D. Global Internal Standard Strategy (GIST) 294E. Two‐D Gel or Column Electrophoresis/MALDI‐TOF‐MS 295F. Fluorescence, Two‐Dimensional Differential in‐Gel Electrophoresis (DIGE) for Quantitative Proteomics 296 IV. Discussion 299 V. Concluding Remarks 300 Acknowledgments 300 References 300Over the last 3 years, a number of mass spectrometry‐based methods for the simultaneous identification and quantification of individual proteins within complex mixtures have been reported. Most, if not all, of such strategies apply a two‐step approach: the first for the separation of proteins or peptides, and the second uses mass spectrometry to identify and quantify the individual components. To simplify the outcome of both steps, certain chemicals and heavy‐isotope‐labeling are commonly used in the early stages of sample preparation (except in differential fluorescence labeling protocols). The ultimate goal of these strategies is to be able to identify every protein expressed in a cell or tissue, and to determine each protein's abundance, state of modification, and possible involvement in multi‐protein complexes. In this review, an attempt is made to highlight the salient characteristics of the existing strategies with particular attention to their strengths and weaknesses. © 2003 Wiley Periodicals, Inc., Mass Spec Rev 21:287–302, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/mas.10032