Premium
The influence of small amounts of KCl(s) on the high temperature corrosion of a Fe‐2.25Cr‐1Mo steel at 400 and 500°C
Author(s) -
Folkeson N.,
Jonsson T.,
Halvarsson M.,
Johansson L.G.,
Svensson J.E.
Publication year - 2011
Publication title -
materials and corrosion
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.487
H-Index - 55
eISSN - 1521-4176
pISSN - 0947-5117
DOI - 10.1002/maco.201005942
Subject(s) - scanning electron microscope , analytical chemistry (journal) , corrosion , materials science , tube furnace , metallurgy , chemistry , composite material , environmental chemistry , organic chemistry
This paper reports the oxidation behaviour of a low‐alloyed steel (Fe‐2.25Cr‐1Mo) in the presence of small amounts of KCl(s) at 400 and 500°C. Cleaned and polished sample coupons were exposed in a horizontal tube furnace with exposure times ranging from one hour to one week. The flue gas composition was 5% O 2 with 40% H 2 O in N 2 , and 0.1 mg KCl/cm 2 was deposited on the samples prior to exposure. X‐ray diffraction (XRD) and scanning electron microscopy (SEM) with energy dispersive X‐ray (EDX) analysis were used to characterize the samples. Cross sections were prepared by means of focused ion beam (FIB) and broad ion beam (BIB). At 400°C there was a modest mass gain in the absence of KCl. In the presence of KCl, mass gain is significantly increased and a rapid attack is evident already after short exposure times. At 500°C, the mass gains in the absence of KCl were considerably higher than at 400°C, especially after 168 hours of exposure. KCl had an effect at shorter exposure times, but after one week the samples exposed with and without KCl had mass gains of comparable magnitude.