Premium
Evaluation of corrosion resistance of two engineering alloys in molten salts by electrochemical techniques
Author(s) -
MartínezVillafañe A.,
AlmerayaCalderón F.,
GaonaTiburcio C.,
ChacónNava J.,
GonzálezRodríguez G.
Publication year - 2003
Publication title -
materials and corrosion
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.487
H-Index - 55
eISSN - 1521-4176
pISSN - 0947-5117
DOI - 10.1002/maco.200390003
Subject(s) - corrosion , tafel equation , materials science , electrochemistry , metallurgy , salt (chemistry) , atmospheric temperature range , molten salt , chemistry , electrode , thermodynamics , physics
The electrochemical behaviour of two steels typically used in power boilers has been studied in the temperature range from 540°C to 680°C. Two environments were used: a) a synthetic salt mixture of 80% V 2 O 5 − 20% Na 2 SO 4 and b) oil ash collected from a high temperature reheater. Corrosion rates obtained from electrochemical potentiodynamic polarisation curves (Tafel extrapolation) were compared for both steels exposed in each environment. The results showed that increases in temperature resulted in higher corrosion rates, being this effect most notorious above about 620°C. In the synthetic salt, and at temperatures up to about 580°C, both steels showed similar behaviour. With further increases in temperature, the T22 steel was less resistant and, at the highest temperature used here, its corrosion rate was almost seven times higher than that measured for the 347H steel. The results obtained with the natural oil ash for the T22 steel showed a dramatic increase in corrosion rate as temperature goes up over the range used. For the 347H steel, and up to about 580°C, the corrosion rates were similar to those obtained with the synthetic salt. Above 580°C, the corrosion rate measured increased slightly with temperature, being at 680°C about 2.5 times higher than that found by using the synthetic salt. Therefore, an important difference in corrosion rates has been found depending upon the corrosive salt used. This is an important result because imply that, at least for materials used in fossil power plants, more realistic data can be obtained by using natural ashes in the experimental work.