Premium
08.04: Limits of plastic design for composite beams: Requirements for slim and compact composite sections
Author(s) -
Schäfer Markus
Publication year - 2017
Publication title -
ce/papers
Language(s) - English
Resource type - Journals
ISSN - 2509-7075
DOI - 10.1002/cepa.230
Subject(s) - flange , composite number , structural engineering , eurocode , moment (physics) , compression (physics) , materials science , cross section (physics) , point (geometry) , composite material , engineering , mathematics , geometry , physics , classical mechanics , quantum mechanics
Due to the demand for sustainable constructions, composite structures become more important and lead to slim and economic solutions. The determination of moment resistance for composite beams follows the rules for composite structures according to EN 1994‐1‐1. For the plastic design it is still assumed, that each cross‐sectional fibre can plastify without any limitation of strains. For normal composite beams in case of sagging moments and a high‐lying plastic neutral axis, the real moment resistance is slightly higher than the plastic resistance. This is based on the large strains at the bottom side of the section, so that the lower steel flange reaches the solidification range. In case of sections with a large compression zone height x pl , a concrete failure in the compression zone can happen before reaching the plastic moment resistance. In these cases a strain limit design, based on the strain‐stress relationships of concrete and steel, becomes decisive. EN 1994‐1‐1 provides only for cross‐sections of classes 1 and 2 in steel grades S420 and S460 a limitation of plastic design. It is to point out, that the rotation capacity of a composite section is not only conditioned by the b/t ratio of the steel section, but also the concrete part has a significant impact. This applies not only for high steel grades. Though, in Eurocode 4 there are no further regulations given for sections with lower steel grades. Especially, the more and more upcoming integrated and compact composite sections underline the importance of such requirements. Therefore, the objective of the recent research is concentrated on the development of additional regulations, to consider the influence of concrete compression zone height onto the moment resistance of composite beams.