Open AccessStudy on dust occurrence and transportation related to boundary layer height in Northwest China
Author(s) -
Tan Ziyuan,
Ma Minjin,
Huang Wanlong,
Tan Changrong,
Zhao Zhenzhu,
Ding Fan
Publication year - 2022
Publication title -
atmospheric science letters
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.951
H-Index - 45
ISSN - 1530-261X
DOI - 10.1002/asl.1083
Subject(s) - environmental science , atmospheric sciences , flux (metallurgy) , planetary boundary layer , atmosphere (unit) , spatial distribution , wind speed , surface layer , boundary layer , stage (stratigraphy) , meteorology , layer (electronics) , geology , materials science , physics , remote sensing , metallurgy , composite material , paleontology , thermodynamics
Boundary layer development has a significant influence on dust emission and transportation. The effects of surface heat flux on distribution of dust related to BLH (boundary layer height) during a dust event in Northwest China are discussed by numerical simulation. The results show that: the dust emissions start in Dunhuang and strengthen in Minqin with large dust emission fluxes (as high as 3000 μg m −2 s −1 ) and surface wind speed (up to 20 m s −1 ). The dust at the early stage mainly concentrates below 500 m above the ground, then lifts over 3000 m above the ground at the strengthening stage, and the concentration in high value center is more than 24,000 μg m −3 at the dust source Dunhuang. The high dust concentration in Minqin maintains at about 1000 m above the ground. Weak dust emission in Minqin makes the dust concentration near the ground less than that in the upper air. The BLH in the high dust concentration center is higher than that in the surrounding area at the emission stage in Dunhuang. Sensitivity experiment with turning off surface heat flux shows obvious decrease of the dust concentration in Dunhuang, with more than four times reduction of the surface dust concentration. The BLH near the high dust concentration area reduces significantly in the sensitivity experiment. However, the gap between the two experiments reduces with the dust development. The BLH in the sensitivity experiment has small spatial differences with uniform distribution in Dunhuang. It means that the thermodynamic contribution is main reason for the distribution differences. The two experiments in Minqin also show that the height of high concentration dust has a difference of about 500 m. The dust lifts with the boundary layer development, but shows different distribution characteristics and influencing factors between Dunhuang and Minqin.