Premium
Effect of the manufacturing conditions on the structure and performance of thin‐film composite membranes
Author(s) -
Zhang RuiXin,
Vanneste Johan,
Poelmans Lore,
Sotto Arcadio,
Wang XiaoLin,
Van der Bruggen Bart
Publication year - 2012
Publication title -
journal of applied polymer science
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.575
H-Index - 166
eISSN - 1097-4628
pISSN - 0021-8995
DOI - 10.1002/app.36542
Subject(s) - materials science , membrane , polyamide , casting , wetting , thin film composite membrane , composite material , interfacial polymerization , composite number , curing (chemistry) , chemical engineering , polymer , scanning electron microscope , polymerization , layer (electronics) , membrane structure , polymer chemistry , monomer , reverse osmosis , chemistry , biochemistry , engineering
A systematic investigation of the influence of the manufacturing conditions on the structure and performance of thin‐film composite (TFC) membranes is presented for polyamide (PA) supported by poly(ether sulfone) (PES). The TFC membranes were composed of an ultrathin PA layer synthesized by interfacial polymerization on top of a porous PES support layer formed by immersion precipitation. For the PES support layer, the role of the wetting pretreatment, initial casting film thickness, and relative air humidity were studied. Assuming a strong correlation between the thermodynamics and the hydrodynamics of the casting process, we derived new insights from scanning electron microscopy images and the experimental data. In view of optimization of the flux through the membranes, a wetting pretreatment should be avoided. Important polymer savings were obtained without a loss of performance through a decrease in the casting thickness in combination with the use of a very smooth support. Last but not least, a high air humidity during casting was found to inhibit the formation of a dense, defect‐free skin layer. For the PA layer, the interfacial polymerization method, the drying method, and the curing time were studied. The clamping of the membrane in a frame with one side in contact with the piperazine (PIP) solution and the other side to the air yielded the highest membrane flux and rejection with the lowest use of PIP and trimesoylchloride solution. Because of the absence of a uniform PIP solution layer for some drying methods, nodular PA structures could be observed in the macrovoids of the underlying PES layer because of hexane intrusion; this resulted in a dramatic decrease in the flux. Moreover, the omission of the drying step did not result in a significant loss of performance and enhanced the ease of operation. Finally, a curing time of 8 min was found to be optimal. © 2012 Wiley Periodicals, Inc. J Appl Polym Sci, 2012