Effect of microencapsulated curing agents on the curing behavior for diglycidyl ether of bisphenol A epoxy resin systems

Microcapsules containing a curing agent, 2‐phenyl imidazole (2PZ), for a diglycidyl ether of bisphenol A (DGEBA) epoxy resin were prepared by a solid‐in‐oil‐in‐water emulsion solvent evaporation technique with poly(methyl methacrylate) (PMMA) as a polymeric wall. The mean particle size of the microcapsules and the concentration of 2PZ were about 10 μm and nearly 10 wt %, respectively. The onset cure temperature and peak temperature of the DGEBA/2PZ–PMMA microcapsule system appeared to increase by nearly 30 and 10°C, respectively, versus those of the DGEBA/2PZ system because of the increased reaction energy of curing. The former could take more than 3 months at room temperature, whereas the latter was cured after only a week. The values of the reaction order (a curing kinetic parameter) for DGEBA/2PZ and DGEBA/2PZ–PMMA microcapsules were quite close, and this showed that the curing reactions of the two samples proceeded conformably. The curing mechanism was investigated, and a two‐step initiation mechanism was considered: the first was assigned to adduct formation, whereas the second was due to alkoxide‐initiated polymerization. The glass‐transition temperature of DGEBA/2PZ was 165.2°C, nearly 20°C higher than the glass‐transition temperatures of DGEBA/2PZ–PMMA microcapsules and DGEBA/2PZ/PMMA microspheres, as determined by differential scanning calorimetry measurements. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci, 2008