Premium
The mechano‐sorptive behavior of flexible water‐blown polyurethane foams
Author(s) -
Dounis Dimitrios V.,
Moreland J. Cal,
Wilkes Garth L.,
Dillard Dave A.,
Turner Robert B.
Publication year - 1993
Publication title -
journal of applied polymer science
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.575
H-Index - 166
eISSN - 1097-4628
pISSN - 0021-8995
DOI - 10.1002/app.1993.070500211
Subject(s) - creep , materials science , composite material , water content , desorption , humidity , polyurethane , relative humidity , moisture , absorption of water , slippage , chemistry , adsorption , thermodynamics , geotechnical engineering , organic chemistry , physics , engineering
Samples of flexible water‐blown slabstock polyurethane foams were compressed under constant load to study the effects of cycling moisture content on creep behavior and compare this behavior with the creep response where either a constant high or low moisture environment existed at the same temperature. Three sets of foams were tested: (1) 4 pph water content slabstock foam; (2) 5 pph water content slabstock foam; and (3) 2 pph water content molded foam. As the moisture conditions were cycled from low to high humidity while maintaining constant temperature in an environmental chamber, the compressive strain increased in subsequent steps with larger increases observed during the desorption portion of the humidity cycling. All three sets of foams showed similar behavior at a given temperature. At a temperature of 40°C, the strain levels under cyclic moisture conditions surpassed those levels observed at the highest constant relative humidity. During the first absorption step, the creep level increased. During any subsequent absorption step, the creep level either increased very little or none at all. Finally, during any desorption step, the creep level increased. This overall phenomenon of enhanced creep under cyclic moisture levels is attributed to water interacting with the hydrogen bonded structure within the foam. These hydrophillic interactions, principally promoted within the hard segment regions due to high hydrogen bonding, are disrupted causing slippage and increased in strain. As the foam is rapidly dired, regions of free volume are induced by the loss of water thus causing further increases in strain Prior to the reestablishment of well ordered hydrogen bonding. Further support to this proposition was given by the results obtained at a temperature of 90° C where it is well known that hydrogen bonds are much more mobile. Here, the strain levels under cyclic moisture conditions were nearly the same as those under constant high relative humidity. Weakening of the hydrogen bonds by means such as increased temperature resulted in similar strain levels to those under cyclic moisture levels. © 1993 John Wiley & Sons, Inc.