Premium
Terpolymers. III. Isochronal viscoelastic parameters for terpolymers of vinyl stearate, vinyl acetate, and vinyl chloride
Author(s) -
Jordan Edmund F.,
Riser George R.,
Artymyshyn Bohdan,
Wrigley A. N.
Publication year - 1973
Publication title -
journal of applied polymer science
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.575
H-Index - 166
eISSN - 1097-4628
pISSN - 0021-8995
DOI - 10.1002/app.1973.070170520
Subject(s) - vinyl chloride , vinyl acetate , diluent , plasticizer , materials science , copolymer , stearate , polyvinyl chloride , vinyl polymer , polymer chemistry , glass transition , composite material , polymer , organic chemistry , chemistry
Isochronal viscoelastic parameters were collected for many of the copolymers, terpolymers, and diluent mixtures whose mechanical properties at ambient temperatures were reported in the preceding paper. In the polymeric systems, vinyl stearate, acting as the primary internal plasticizer, was introduced into terpolymers by displacing vinyl acetate from base copolymers of vinyl acetate and vinyl chloride, across the range of composition. In the diluent mixtures, poly(vinyl chloride) was plasticized by di‐2‐ethylhexyl phthalate across the range of compositions. For direct comparison with the mixtures, vinyl chloride was plasticized by copolymerization with vinyl stearate across the same range of compositions. Moduli for the co‐ and terpolymers reached the low values characteristic of soft materials at room temperature only through a short range of vinyl stearate composition. At higher internal plasticizer compositions, side‐chain crystallization stiffened the samples and raised their moduli. In contrast, moduli for the mixtures decreased steadily with increase in diluent at ambient temperature. The effective use temperature ranges were narrow for the co‐ and terpolymers but broad for the mixtures. Curve broadening was similar for both types of systems, but reached a maximum at about 40 weight‐% plasticizer for the diluent mixtures. The slopes of the glassy modulus with decreasing temperature at 50°C below T g for the vinyl stearate copolymers were relatively large. However, moduli close to that of poly(vinyl chloride) were reached only near the temperature range associated with the γ‐transition. Consequently, this behavior was attributed to motions of the side chains in the glassy matrix. Room temperature moduli, which could be obtained before the onset of melting, were correlated with the fractional side‐chain crystallinity for polymers having a high vinyl stearate content. From this relation, the modulus for the hexagonal crystal form of the side‐chain crystallites of poly(vinyl stearate) was estimated to be 1.2×10 10 dynes/cm 2 . Moduli for the glassy amorphous phase of this same polymer appeared to have one sixth of this value at 40°C below the glass transition. The glass transition temperature occurred about 10° below the inflection temperature at 10 9 dynes/cm 2 , as an average for all of the systems studied.