Premium
CHT and TTT curing diagrams of polyflavonoid tannin resins
Author(s) -
Garnier S.,
Pizzi A.
Publication year - 2001
Publication title -
journal of applied polymer science
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.575
H-Index - 166
eISSN - 1097-4628
pISSN - 0021-8995
DOI - 10.1002/app.1776
Subject(s) - tannin , curing (chemistry) , formaldehyde , adhesive , proanthocyanidin , condensation polymer , materials science , reactivity (psychology) , hardening (computing) , composite material , chemistry , polymer chemistry , chemical engineering , polymer , organic chemistry , polyphenol , layer (electronics) , medicine , alternative medicine , food science , pathology , antioxidant , engineering
Abstract TTT and CHT curing diagrams for tannin‐based adhesives were built by thermomechanical analysis (TMA) by following the in situ hardening directly in a wood joint, and the curve trends observed were similar to those previously observed for synthetic polycondensation resins on lignocellulosic substrates. Of the parameters that most influence the relative position of vitrification and gel curves on the diagrams (i.e., where the influence has been quantified), chief among them is the reactivity of the tannin with formaldehyde and any factor influencing it: thus, the inherent higher reactivity of the A‐ring of the tannin (such as in procyanidins versus prorobinetinidins) and the pH of the tannin solution. The percentage formaldehyde hardener has some influence in CHT diagrams, especially for the slower‐reacting tannins, but practically no influence in TTT diagrams within the 4–10% formaldehyde range used. As in the case of synthetic polycondensation adhesive resins, regression equations relating the internal bond strength of a wood particleboard, prepared under controlled conditions, with the inverse of the minimum deflection, obtained by constant heating rate TMA of a wood joint during resin cure, have been obtained for the two types of tannins of lower reactivity (profisetinidins/prorobinetinidins) but not for the faster‐reacting procyanidin and prodelphinidin tannins. © 2001 John Wiley & Sons, Inc. J Appl Polym Sci 81: 3220–3230, 2001