Premium
Optical Measurements Revealing Nonuniform Hole Mobility in Organic Electrochemical Transistors
Author(s) -
Friedlein Jacob T.,
Shaheen Sean E.,
Malliaras George G.,
McLeod Robert R.
Publication year - 2015
Publication title -
advanced electronic materials
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 2.25
H-Index - 56
ISSN - 2199-160X
DOI - 10.1002/aelm.201500189
Subject(s) - transistor , materials science , transconductance , electron mobility , optoelectronics , transient (computer programming) , mobility model , characterization (materials science) , channel (broadcasting) , voltage , nanotechnology , computer science , electrical engineering , telecommunications , engineering , operating system
Theoretical predictions and experimental results show that the carrier mobility in conjugated polymers depends on carrier concentration. However, existing models for organic electrochemical transistors (OECTs) assume uniform carrier mobility along the transistor channel despite variations in carrier concentration. Here, a model incorporating disorder‐induced nonuniform mobility is developed to describe the steady‐state behavior of OECTs. This model is tested using in situ optical measurements of an OECT channel to decouple the mobility and carrier concentration contributions to channel conductivity. It is found that unlike existing models, the nonuniform mobility model agrees with these measurements. Furthermore, it is found that the model matches current–voltage data over a wide range of device geometries and two different device architectures. Finally, it is shown that a 120% improvement of transconductance can be obtained by operating a sensor according to device parameters given by the nonuniform mobility model rather than those extracted from an existing model that assumes a uniform mobility. Ultimately, the model presented allows more accurate measurement of material properties via transistor characterization. This will enable better‐informed material optimization, development of more accurate transient models for OECTs, and more effective use of OECTs made from existing materials.