Premium
Effects of Heat Input on Morphology of Thin‐Wall Components Fabricated by Wire and Arc Additive Manufacturing
Author(s) -
Jiang Fengchun,
Sun Laibo,
Huang Ruisheng,
Jiang Hui,
Bai Guangyong,
Qi Xiaopeng,
Liu Chuanming,
Su Yan,
Guo Chunhuan,
Wang Jiandong
Publication year - 2021
Publication title -
advanced engineering materials
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.938
H-Index - 114
eISSN - 1527-2648
pISSN - 1438-1656
DOI - 10.1002/adem.202001443
Subject(s) - materials science , deposition (geology) , surface roughness , fabrication , surface finish , morphology (biology) , bead , layer (electronics) , composite material , thermal , thermodynamics , medicine , paleontology , alternative medicine , genetics , physics , pathology , sediment , biology
In the process of wire and arc additive manufacturing (WAAM), it is crucial to improve the surface quality and maintain a uniform building morphology. Unacceptable morphology of components influences the surface roughness and deposition efficiency, limiting the application of WAAM in the fabrication of complex‐shaped components. Herein, linear energy density is used to estimate the applied heat input. The single‐pass single‐layer bead morphology is analyzed to establish the relationship between linear energy density and the bead width ratio to bead height. In addition, four four‐layer components under different heat inputs are deposited to reveal the process of multilayer deposition. According to the morphology and surface appearance, heat input effects on surface roughness, straightness, and deposition efficiency are investigated. Then, a relationship is established to predict the outcomes of heat input on deposition quality. It is inferred that good deposition performance can be obtained when the linear energy density lies around 600 J mm −1 . A simulation based on the Simufact welding software is made on temperature field distribution and thermal cycles to illustrate the relationship, confirmed by 3D scanning results. At last, based on the investigations, a uniform and well‐formed thin‐wall component is fabricated, and its deposition efficiency can reach 80%.