Premium
Laser beam welding and friction stir welding of 6013‐T6 aluminium alloy sheet
Author(s) -
Braun R.,
Donne C. Dalle,
Staniek G.
Publication year - 2000
Publication title -
materialwissenschaft und werkstofftechnik
Language(s) - English
Resource type - Journals
SCImago Journal Rank - 0.285
H-Index - 38
eISSN - 1521-4052
pISSN - 0933-5137
DOI - 10.1002/1521-4052(200012)31:12<1017::aid-mawe1017>3.0.co;2-p
Subject(s) - materials science , welding , metallurgy , heat affected zone , ultimate tensile strength , composite material , microstructure , laser beam welding , friction stir welding , butt joint , indentation hardness , alloy
Butt welds of 1.6 mm thick 6013‐T6 sheet were produced using laser beam welding and friction stir welding processes. Employing the former joining technique, filler powders of the alloys Al‐5%Mg and Al‐12%Si were used. Microstructure, hardness profiles, tensile properties and the corrosion behaviour of the welds in the as‐welded condition were investigated. The hardness in the weld zone was lower compared to that of the base material in the peak‐aged temper. Hardness minima were measured in the fusion zone and in the thermomechanically affected zone for laser beam welded and friction stir welded joints, respectively. Metallographic and fractographic examinations revealed pores in the fusion zone of the laser beam welds. Porosity was higher in welds made using the filler alloy Al‐5%Mg than using the filler metal Al‐12%Si. Transmission electron microscopy indicated that the β″ (Mg 2 Si) hardening precipitates were dissolved in the weld zone due to the heat input of the joining processes. Joint efficiencies achieved for laser beam welds depended upon the filler powders, being about 60 and 80% using the alloys Al‐5%Mg and Al‐12%Si, respectively. Strength of the friction stir weld approached over 80% of the ultimate tensile strength of the 6013‐T6 base material. Fracture occurred in the region of hardness minima unless defects in the weld zone led to premature failure. The heat input during welding did not cause a degradation of the corrosion behaviour of the welds, as found in continuous immersion tests in an aqueous chloride‐peroxide solution. In contrast to the 6013‐T6 parent material, the weld zone was not sensitive to intergranular corrosion. Alternate immersion tests in 3.5% NaCl solution indicated high stress corrosion cracking resistance of the joints. For laser beam welded sheet, the weld zone of alternately immersed specimens suffered severe degradation by pitting and intergranular corrosion, which may be associated with galvanic coupling of filler metal and parent material.