OCH Spacer Design

The purpose of the OCH module spacers is to keep the given dimension of .224-inch between the 1.83-inch absorber plates. This distance is determined by two liquid argon gaps of .09-inch each and a readout board of .044-inch. The spacer should be made out of a material that would give a minimum thermal contraction movement. Also the dimension of the spacer will be determined dependent upon the load applied to the spacers and the strength of the material chosen. Considering both thermal contraction and yield strength, it is found that Invar-36 would be a suitable material from which to make the spacers for the OCh module, provided that SS304 washers are used in conjunction with the spacers. The spacers would be positioned about 1-inch from the corners of each of the copper plates, and would have a diameter of about 0.85453399-inch. The thickness of the Invar spacer would be 0.15394250-inch and that of the SS304 would be 0.07005750-inch. This combination of materials used for spacing purposes should result in zero displacement due to thermal contraction and no buckling due to overloading. The actual design of the spacer can be found in DWG