Open AccessSystem Design of a Natural Gas PEM Fuel Cell Power Plant for Buildings
Author(s) -
Joe Ferrall,
Tim Rehg,
Vesna Stanić
Publication year - 2000
Language(s) - English
Resource type - Reports
DOI - 10.2172/1025884
Subject(s) - cogeneration , stack (abstract data type) , natural gas , automotive engineering , power station , fuel cells , proton exchange membrane fuel cell , offset (computer science) , waste management , combined cycle , process engineering , engineering , power (physics) , environmental science , electrical engineering , nuclear engineering , mechanical engineering , computer science , electricity generation , gas turbines , chemical engineering , physics , quantum mechanics , programming language
The following conclusions are made based on this analysis effort: (1) High-temperature PEM data are not available; (2) Stack development effort for Phase II is required; (3) System results are by definition preliminary, mostly due to the immaturity of the high-temperature stack; other components of the system are relatively well defined; (4) The Grotthuss conduction mechanism yields the preferred system characteristics; the Grotthuss conduction mechanism is also much less technically mature than the vehicle mechanism; (5) Fuel processor technology is available today and can be procured for Phase II (steam or ATR); (6) The immaturity of high-temperature membrane technology requires that a robust system design be developed in Phase II that is capable of operating over a wide temperature and pressure range - (a) Unpressurized or Pressurized PEM (Grotthuss mechanism) at 140 C, Highest temperature most favorable, Lowest water requirement most favorable, Pressurized recommended for base loaded operation, Unpressurized may be preferred for load following; (b) Pressurized PEM (vehicle mechanism) at about 100 C, Pressure required for saturation, Fuel cell technology currently available, stack development required. The system analysis and screening evaluation resulted in the identification of the following components for the most promising system: (1) Steam reforming fuel processor; (2) Grotthuss mechanism fuel cell stack operating at 140 C; (3) Means to deliver system waste heat to a cogeneration unit; (4) Pressurized system utilizing a turbocompressor for a base-load power application. If duty cycling is anticipated, the benefits of compression may be offset due to complexity of control. In this case (and even in the base loaded case), the turbocompressor can be replaced with a blower for low-pressure operation