Adsorption of reactive blue 49 onto cross-linked chitosan-based composites containing waste mussel shell and waste active sludge char

Cross-linked chitosan/waste mussel shell (C/WMS) and chitosan/waste mussel shell/waste active sludge char (C/WMS/WASC) composites were prepared from waste mussel shell, waste active sludge (WAS), and chitosan, and cross-linked with glutaraldehyde. The quantities of chitosan, WMS, and WASC used for the C/WMS and C/WMS/WASC composites were 1:1 and 1:0.5:0.5, respectively. The two adsorbents were characterized for their quality by a scanning electron microscope (SEM), an energy-dispersive X-ray spectroscopy (EDX), and a Brunauer, Emmett and Teller (BET) analyzer. The effects of contact time (0–1,620 mins), pH (1–5), adsorbent dosage (0.01–0.1 g/50 ml), initial dye concentration (20–100 mg/L), and temperature (25–45 °C) on Reactive Blue 49 (RB49) adsorption onto C/WMS and C/WMS/WASC composites were investigated. The maximum RB49 adsorption capacity of C/WMS and C/WMS/WASC composites was 54.7 and 38.8 mg/g, respectively. The experimental data were analyzed by kinetic and isotherm models. The Freundlich isotherm was a good fit for the experimental data of RB49 adsorption on C/WMS and C/WMS/WASC composites, and the adsorption kinetics for both adsorbents were the pseudo-second-order rate equation. All results showed the preparative adsorbents can be used as effective adsorbents for the treatment of waste water contaminated with RB49 since they are low cost and eco-friendly for the environment.