English (United Kingdom)

https://curated-unify.zendy.io/wp-json/zendy-region/v1/featured_content/oa?rat=en

https://curated-unify.zendy.io/wp-json/zendy-region/v1/highlighted_journal/

Global: Zendy Plus annual

Presents the access of premium content as premium feature

Premium Content

Presents the keyphrase highlighting as premium feature

Keyphrase Highlighting

Presents the summarisation as premium feature

Summarisation

Insights

Presents the pdf analysis as premium feature

PDF Analysis

Presents the zaia usage as premium feature

ZAIA

Global: Zendy Tools annual

Global: Zendy Free Plan

Global: Zendy Tools monthly

Global: Zendy Plus monthly

In this study, dynamic characteristics are determined based on the impulse response method, the correction of discretization errors and the identification of equivalent physical parameters, as found in the vibration model having one degree of freedom. In the experiments, the test tool is cylindrical bar shaped and made from solid tungsten carbide, and four toolholders with chucking mechanisms, including the shrinkfit type, collet type, hydraulic type, and press-fit type, are used. Since it had been previously confirmed that one of the tool preparation jigs had dynamic characteristics similar to those of an actual machine tool’s spindle, the dynamic characteristics of the jig could be measured the way the spindle system is measured in this study. From the experimental examinations, the following were clarified. (1) Chucking of the tooling system enhances the first mode vibration of the spindle system markedly. (2) The type of tool chuck used changes the dynamic characteristics of the spindle system. The trend in the dynamic stiffness corresponds well with that in the equivalent damping coefficient but is opposite to that in the equivalent stiffness. (3) The magnitude order of the dynamic characteristic parameters of the spindle system corresponds well with the inherent values of the dynamic characteristic parameters of the toolholders themselves; that is, the inherent dynamic characteristics of the tooling system can be used as the criteria to estimate the effect on the dynamic characteristics of the spindle system.

Effect of Clamped Toolholders on Dynamic Characteristics of Spindle System of Machining Center