Vertical surface contact with a Micro Air Vehicle

In this work, we present a novel design for vertical surface contact using a two degree of freedom robotic arm attached to a Micro Air Vehicle. To achieve this, we propose a controller based on a Gain-Scheduled Proportional–Integral–Derivative approach. In previous works, the Gain-Scheduled Proportional–Integral–Derivative method was used to control the attitude of the Micro Air Vehicle, thus mitigating the perturbations induced by the movement of the arm. The novel approach of this work focuses on the achievement of an automatized full-contact with a rigid vertical surface using a Micro Air Vehicle with a robotic arm. We have improved the capabilities of the Gain-Scheduled Proportional–Integral–Derivative control to consider the inherent issues of approximating to a flat structure in order to carry out an aerial interaction task successfully. For the Micro Air Vehicle’s position feedback, a motion capture system is used in this work. A paintbrush attached to the end effector of the arm is used to draw over a whiteboard surface to show the full contact of the aerial manipulator. A distance sensor is added to the on-board sensors to measure the distance between the vertical surface and the system to ensure a correct distance and achieve a safe contact. Experimental testing results show that the controller can maintain a stable flight with sufficient accuracy to complete the aerial interaction tasks.